Dell C9000 Series Reference Manual page 792

Parameters
eg-acl | in-acl
linecardslot-id
port-set port-pipe
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Example
Dell#show hardware ipv6 eg-acl linecard 0 port-set 0
EID 0x000013ce: gid=0xd,
flags=0x10202, Installed, Enabled
StageEgress
flags=0x10204, Installed, Enabled
IpType
L3Routable
OutPort
Enter either the keyword eg-acl or the keyword in-acl to
display ingress or egress ACL data.
Enter the linecard slot-id parameters to specify a line card
on the switch. The range of slot IDs is from 0 to 2.
Enter the keywords port-set port-pipe parameters to
specify a port pipe (set of ports) on a line card. The range of
port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3 on line
cards 1 and 2.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
slice=0, slice_idx=0, part =0 prio=0x13ce,
tcam: color_indep=0,
slice=1, slice_idx=0, part =1 prio=0x13ce,
tcam: color_indep=0,
Offset: 1 Width: 8
DATA=0x0000003a
MASK=0x000000ff
Offset: 208 Width: 5
DATA=0x00000004
MASK=0x0000000c
Offset: 166 Width: 1
DATA=0x00000001
MASK=0x00000001
Offset: 195 Width: 7
DATA=0x00000001
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0), param2=0(0),
Debugging and Diagnostics 792