arp inspection-trust
Specify a port or an interface as trusted so that ARP frames are not validated against the binding table.
C9000 Series
Syntax
arp inspection-trust
Defaults
Disabled
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
Related
arp inspection
Commands
clear ip dhcp snooping
Clear the DHCP binding table.
C9000 Series
Syntax
clear ip dhcp snooping binding
Defaults
none
•
INTERFACE
•
INTERFACE PORT-CHANNEL
•
INTERFACE PORT EXTENDER (conf-if-pegi-pe-id/Unit/Port)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
— enables dynamic ARP inspection on a VLAN.
Dynamic Host Configuration Protocol (DHCP)
826