DSC Test Call by Manually Entering an MMSI
[
] "DSC CALL" "DSC TEST CALL" "MANUAL"
1.
2. Rotate the DIAL/ENT knob to select "MANUAL", then
press the [SELECT] soft key.
3. Rotate the DIAL/ENT knob to select the first digit in
the MMSI, then press the [SELECT] soft key.
4. Repeat step 3 until all the numbers of the MMSI are
shown on the display.
5. Press the [FINISH] soft key to show the test call page.
6. Press the [YES] soft key to transmit the DSC test call
to the other vessel.
7. Press the [QUIT] soft key to return to radio operation.
After the radio receives a test call reply from the vessel that was called,
the radio will ring and show "RX TEST CALL" display, which confirms
the radio you called has received the test call.
10.10.3 Receiving a DSC Test Call
When another vessel transmits a DSC Test call to the GX6000 the following
will happen:
1. When a DSC Test call is received, the radio will auto-
matically respond to the calling vessel.
2. To exit from the DSC Test call display, press the [QUIT]
soft key.
80
NOTE