Standard Horizon QUANTUM AIS GX6000 Owner's Manual page 72

4. Press the [QUIT] soft key to return to the channel
display.
When there is an unread position request call, "
the display. You may review the unread individual call from the DSC
log, refer to the section "10.11.3 Reviewing Other Logged Calls".
10.6.4 Manual Input of Position Information
If the GX6000 is located in an area where GPS reception is limited when you
are going to reply to the received position request, you may manually input
your location (latitude and longitude) and time to be sent.
[ ]  "MMSI/POS INFO"
1.
2. Press the [POS/TM] soft key.
3. Rotate the DIAL/ENT knob to select the first number
of latitude, then press the [SELECT] soft key to step
to the next number.
4. Repeat step 3 to set the position and time.
If a mistake was made, rotate the DIAL/ENT knob to
select "←" or "→", press the [SELECT] soft key until
the wrong character is selected, then perform step 3.
5. When finished programming the position and time, press the [FINISH] soft
key. The display will return to the previous screen.
6. Press the [OK] soft key.
7. Press the CLEAR key to return to radio operation.
70
NOTE
" icon will appear on