Demo Mode - Standard Horizon QUANTUM AIS GX6000 Owner's Manual

1. Select a channel that was programmed for scrambler
mode (the "
2. Monitor the channel before transmitting.
3. Transmit the voice message. The transmission sent
will be scrambled.
8.16

DEMO MODE

This mode is used by Standard Horizon sales persons and dealers to demonstrate radio,
DSC and AIS functions. Demo mode allows latitude, longitude and time to be entered
to simulate radio displays. When the demo mode is enabled, the radio display will
automatically switch from the NORMAL, COMPASS, WAYPOINT, AIS and GM displays.
When demo mode is enabled and the radio is turned off and back on
the radio will still be in the demo mode.
]  "SETUP"  "ABOUT..."  "DEMO OPERATION" 
[
1.
"DEMO POSITION INPUT"
2. Enter the latitude/longitude of your vessel and your
local UTC time in the 24-hour notation by the DIAL/
ENT knob. Rotate the DIAL/ENT knob to select the
number and press the [SELECT] soft key to move
the cursor to the next character.
3. If a mistake was made entering in the latitude/longitude of your vessel and
your local UTC time, rotate the DIAL/ENT knob to select "←" or "→", press
the [SELECT] soft key until the wrong character is selected, then perform
step 2.
4. To store the data entered, press the [FINISH] soft key.
5. Rotate the DIAL/ENT knob to select "DEMO START",
then press the [SELECT] soft key.
6. Rotate the DIAL/ENT knob to select "START", then
press the [SELECT] soft key.
To stop the demo mode, select "STOP" in step 6 above.
46
" icon will appear on the display).
NOTE
NOTE