Standard Horizon QUANTUM AIS GX6000 Owner's Manual page 26

7.5.8 Optional SSM-70H (RAM4) Installation
The GX6000 is capable of using two SSM-70H (RAM4) Remote Station
Microphones to remotely control the Radio, AIS, DSC and PA/Fog functions. In
addition the GX6000 can operate as a full function intercom system between
the SSM-70H (RAM4) and the GX6000.
Do not connect or remove the SSM-70H (RAM4) microphone while
the radio is powered on. This may result in equipment failure.
1. Connect the Routing Cable (supplied
with the SSM-70H) to the RAM-1 or
the RAM-2 eight pin connector on
the GX6000 rear panel, then tighten
the cable nut.
2. Install the two ferrite core (supplied with the SSM-70H Remote Station
Microphone) to the routing cable or the CT-100 extension cable, then snap
its two halves together. These require to install near the connector by the
each side of a transceiver and a microphone of the cable.
3. Attach the ferrite cores as close as possible to the plugs, as shown below.
to GX6000
As close as possible
Caution!: Before cutting the cable, it must be disconnected from the rear
panel of the transceiver.
The routing cable can be cut and spliced, however care needs to be taken
when reconnecting the wires to ensure water integrity.
After cutting you will notice there are the following wires:
Yellow, White, Brown, Gray, Blue, Green, Red/White
 The red/white and shield wires are wrapped in foil. Remove the foil, and
separate the red/white and shield wires.
24
WARNING
Ferrite Core
Routing Cable or
CT-100 Extension Cable
Ferrite Core
As close as possible
NOTE

External Speaker
Connections
to SSM-70H
(RAM4)
, Shield
