Cisco Nexus 7000 Series Configuration Manual page 86

Nx-os quality of service configuration guide
Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

Configuring 1-Rate and 2-Rate, 2-Color and 3-Color Policing
Action
set dscp dscp table {cir-markdown-map |
pir-markdown-map}
Table 24: Policer Actions for Conform
Action
transmit
set-prec-transmit
set-dscp-transmit
set-cos-transmit
set-qos-transmit
set-discard-class-transmit
Note
The policer can only drop or mark down packets that exceed or violate the specified parameters. For information
on marking down packets, see "Configuring Marking."
The data rates used in the police command are described in the table below.
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
70
Description
Sets the specified fields from a table map and
transmits the packet. For more information on the
system-defined or default table maps, see
"Configuring Marking." This action is available only
when the packet exceeds the parameters (use the
cir-markdown-map) or violates the parameters (use
the pir-markdown-map).
If the packet has a CoS value configured
Note
on VLAN, then the CoS value is used to
set the value for the DSCP field.
Description
Transmits the packet. This action is available only
when the packet conforms to the parameters.
Sets the IP precedence field to a specified value and
transmits the packet. This action is available only
when the packet conforms to the parameters.
Sets the Differentiated Service Code Point (DSCP)
field to a specified value and transmits the packet.
This action is available only when the packet conforms
to the parameters.
Sets the class of service (CoS) field to a specified
value and transmits the packet. This action is available
only when the packet conforms to the parameters
Sets the QoS group internal label to specified value
and transmits the packet. This action can be used only
in input policies and is available only when the packet
conforms to the parameters.
Sets the discard-class internal label to a specified value
and transmits the packet. This action can be used only
in ingress policies and is available only when the
packet conforms to the parameters.
Configuring Policing

Advertisement

Table of Contents
loading

Table of Contents