Configuring Or Modifying A Table Map - Cisco Nexus 7000 Series Configuration Manual

Configuring or Modifying a Table Map

Step 6
Step 7
Step 8
Step 9
Step 10
Configuring or Modifying a Table Map
You can create or modify a table map that you can reference in policy maps. For information on configuring
table maps, see "Configuring Marking."
Procedure
Step 1
Step 2
Step 3
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
20
Command or Action
switch(config)# class-map type queuing
match-any {class-queuing-name | WORD}
switch(config-cmap-que)# exit
(Optional) switch(config)# show class-map
[type qos] [class-map-name |
conform-color-in | conform-color-out |
exceed-color-in | exceed-color-out]
(Optional) switch(config)# show class-map
type queuing [class-queuing-name]
(Optional) switch(config)# copy
running-config startup-config
Command or Action
switch# configure terminal
switch(config)# table-map table-map-name
switch(config-tmap)# exit
Using Modular QoS CLI
Purpose
Creates or accesses the class map of type
queuing, and then enters class-map queuing
mode. Class queuing names are listed in
6: System-Defined Type queuing Class Maps,
on page 15.
Note The match on WORD is used for
defining hierarchical class maps.
The argument, WORD, is supported
only on the F-Series Modules.
Exits class map queuing mode and enters
global configuration mode.
Displays information about all configured class
maps or a selected class map of type qos.
Displays information about all configured class
maps or a selected class map of type queuing.
Class queuing names are listed in
System-Defined Type queuing Class Maps, on
page 15.
Saves the running configuration to the startup
configuration.
Purpose
Enters global configuration mode.
Creates or accesses the table map and then
enters table-map mode. Table map names can
contain alphabetic, hyphen, or underscore
characters, are case sensitive, and can be up to
40 characters.
Exits table-map mode and enters global
configuration mode.
Table
Table 6: