Special Functions; Reset All Parameter Settings To User Default Values - ABB PSE 18 Installation And Commissioning Manual

Ready Run Protection
Exit
Figure 7.33: Entering menu Reset all settings
to user default values
Figure 7.34: Reset All Settings to user default
values parameter displayed
74 Chapter 7 Softstarters Type PSE18...PSE370 Installation and commissioning manual 1SFC132057M0201

7.7 Special functions

Fault

7.7.1 Reset all parameter settings to user default values

Start from Information Level and press in sequence the keys Exit and Select for a
few seconds, as described in figure 7.29. The text string "rES" will be displayed
on the LCD as in figure 7.34.
Press Select to enter Reset All Settings, and the text string "rES" on the LCD
starts flashing.
Press Exit key to cancel, or press Select to reset all settings.
Select
After reset it is necessary to press Exit for returning to Information Level.
Reset
Caution
The motor may start unexpectedly if there is a start signal present when do-
ing any of the actions listed below.
Switching from one type of control to another (fieldbus control / hard-
•
wire control)
• Resetting all parameters
• Resetting events
If using automatic event reset
•
!