Functional Description - Makita DVC860L Instruction Manual

FUNCTIONAL DESCRIPTION

Use with AC power:
WARNING:
Before plugging the cleaner, always make sure
•
that the cleaner is switched off. Plugging the
cleaner with the switch on may cause an
unexpected start resulting in serious personal
injury.
Fig.1
Connect the plug to a power supply.
Fig.2
The AC power indicator lights up when setting the
stand-by switch to "I" side.
NOTE:
Even operating in DC power mode , the tool is
•
automatically changed into AC power mode when
plugged in.
If the tool is unplugged during operation with the
•
battery inserted, the cleaner gets into stand-by
state.
Use with battery:
Installing or removing battery cartridge
CAUTION:
Always be sure that the cleaner is switched off,
•
unplugged, and the battery cartridge is removed
before adjusting or checking function on the tool.
Hold the cleaner and the battery cartridge
•
firmly when installing or removing battery
cartridge. Failure to hold the cleaner and the
battery cartridge firmly may cause them to slip off
your hands and result in damage to the cleaner
and battery cartridge and a personal injury.
Be careful not to pinch your fingers when
•
opening or closing the battery cover. Failure to
do so may cause personal injury.
Fig.3
To install the battery cartridge, release the lock first, and
open the battery cover. And then, insert the battery
cartridge.
Fig.4
Align the tongue on the battery cartridge with the groove
in the housing and slip it into place. Insert it all the way
until it locks in place with a little click. Then lock the
battery cover.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
NOTICE:
Remove the plug of the cleaner from the extension
•
cord when using the cleaner with the batteries.
CAUTION:
Always install the battery cartridge fully in place. If
•
not, it may accidentally fall out of the tool, causing
injury to you or someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
NOTE:
The cleaner does not work with only one battery
•
cartridge.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life.
The tool will automatically stop during operation if the
tool or battery is placed under one of the following
conditions. In some conditions, the indicators light up.
Overload protection
If the tool is overloaded, the tool stops automatically. In
this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
Overheat protection for tool
On
015485
When the tool is overheated, the tool stops automatically, and
the battery indicator blink about 60 seconds. In this situation,
let the tool cool down before turning the tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Remaining battery capacity indication
Fig.5
015674
8
Blinking
1 1 2 2