Figure 3-23 Data Ranges - Virtual Math - Omega OM-DAQXL-1 Series User Manual

After configuring the channels and math operations for the virtual math channel
on the Input Type screen, you can set up the engineering units and ranges for the
calculated results on the Data Ranges screen.
1
2
1. Engineering Units
These drop downs allow selection of various engineering units for display.
2. Display Range
The display range boxes show the full display range available on the data
logger. The graph range can be any subset of this range. This range should be
set to cover all possible values of the calculated results based on the scaling
and math operations.
3. Zero Adjust
The zero adjust provides a user configurable offset adjustment, in engineering
units, which will be applied to measurements across the full range of input.
4. Moving Average Filter
This setting provides the option to average an individual channels input
samples.
5. Graph Range
The graph range is the y-axis range that will be shown on the waveform view
of the data logger. This can be any subset of the display range and is defined
in the assigned engineering units. It can also be adjusted on the waveform
view.
6. Decimal Places
Selects the number of decimal place to display.
3

Figure 3-23 Data Ranges - Virtual Math

3
Standalone Operation
6
5
4
3-20