9.4
Software Upgrade for PILD
This procedure enables the PILD option in an ST 800 device that was not ordered from the factory.
This requires the user to obtain and install a License Key. This procedure can be performed from both
host application and integral display of the device to activate this option.
Procedure for upgrading the software from HART host application
•
Retrieve the Dev Id parameter shown on the Device Setup->Upgrade Options menu.
•
Reference document PILD Upgrade Option, ST 800 Instruction Sheet (34-ST-33-73) for
firmware revision level requirements.
•
Verify firmware revisions in device meet the following required minimum revision levels for
PILD Option Licensing support:
-
Basic Display: 1.08
-
Advanced Display (Euro): 1.12
-
Advanced Display (Asia): 1.13
-
HART Comm Firmware: 1.10
-
Sensor Firmware: 1.03
Please reference your User Manual on how to obtain firmware revision numbers from a
device. If you need technical support contact Honeywell GTS at 1-800-423-9883.
•
Place an order for the ST 800 PILD Field Upgrade kit, part number 50097038-501. Include
the following information with the order:
-
The Dev Id of the device
-
Feature requires license: PILD Field upgrade for ST 800 (Part Number - 50097038-
501)
•
The factory or Honeywell factory] generates and sends a License Key to customer.
•
The customer installs the license by selecting the "Enter License Key" method on the Device
Setup->Upgrade Options menu.
•
On confirmation of the license activation,
-
The transmitter's integral display, if present, will restart.
-
The PILD Functionality parameter on the Device Setup->Upgrade Options menu will
show the value "Available"
Revision 5.0
ST 800 Series HART/DE Option User's Manual
Page 95