Honeywell DR4300 Getting Started page 2

Instrument Configuration
Upper Display - four characters
Normal operation - Displays process variable (PV) for the selected input channel.
Configuration mode - Displays selection or parameter value.
Data displayed
is for input
Channel 1 or 2
Output relay 1 or 2
is ON, when lit.
Lower Display - six characters
Normal operation - Displays selectable
operating parameter label and value.
With totalization, shows totalizer value.
Configuration mode - Displays Set Up
group and function parameters.
Ready to Start Up
Refer to Table 3-5 or 4-22 in the Product Manual for procedure to set the chart time line.
Turn on the power to the instrument and it will start recording your input. For information on connecting the other
input and output options, refer to Section 2 in the Product Manual.
Technical Assistance
If you encounter a problem with your DR4300 recorder, you can receive technical assistance by dialing
1-800-423-9883 (USA and Canada). An engineer will discuss the problem with you. Please have your complete
model number, serial number, and software version available.
44-01-25-16A
For recorder models
SW1
Configuration switches SW1 and input switches SW6 are provided on
each pen channel's printed circuit assembly.
• Go to Table 3-2 in the Product Manual and find the desired
SW6
combination of recorder selections and input type for the pen 1
channel.
• Set the switches in SW1 and SW6, as indicated in Table 3-2 of the
Product Manual, for pen 1 on the printed circuit assembly on the right
side of the recorder. (Pen 1 is purple.)
• Repeat for pen 2 on its printed circuit assembly, located on the left
side of the recorder (if available).
For recorder models
Input switches SW6 are provided on each pen channel's printed circuit
assembly.
• Go to Table 4-3 in the Product Manual and find the desired input
SW6
type for the pen 1 channel.
• Set the switches in SW6, as indicated in Table 4-3 of the Product
Manual, for pen 1 on the printed circuit assembly on the right side of
the recorder. (Pen 1 is purple.)
• Repeat for pen 2 on its printed circuit assembly, located on the left
side of the recorder (if available).
• Go to Table 4-4 in the Product Manual for the configuration
procedure. Refer to Figure 4-2 in the Product Manual for a
sequenced prompt hierarchy and to Tables 4-5 through 4-18 for
configuration parameter definitions.
INP 1 2
1 2
OUT
DR4300 Circular Chart Recorder – Quick Start Guide
display and keypad
WITHOUT
display and keypad
WITH
Indicates temperature
units of PV on display.
SET
FUNC
UP
F C
MAN
DISP
M A
AUTO
R L
Indicates controller mode:
M = Manual
A = Automatic
When either of the remote switch is set
for SP2, or when NumSPs = TWO
L = Setpoint 1 (SP) active
R = Setpoint 2 (S2) active
Otherwise, neither indicator is used.
11/99