Contour Sanding - Grizzly G1014Z Owner's Manual

4.
While holding the back end of the workpiece
against the backstop with both hands, and
while keeping your fingers away from the
belt, slowly feed the workpiece into the belt,
as shown in Figures 51 & 52.
Note: Apply even pressure and move the
workpiece back and forth across the sanding
belt.
Figure 51. Sanding workpiece in horizontal
position.
Figure 52. Sanding edge of workpiece in
horizontal position.
Sanding surfaces can cause serious person-
al injury if they come in contact with fingers,
hands or other body parts. Use extreme care
to provide a safe distance between the belt
and any part of your body.
Model G1014Z/G1014ZX (Mfd. Since 07/17)

Contour Sanding

To perform contour sanding:
1.
Make sure the sanding belt is tensioned—if it
is not already tight.
2.
Make sure the belt tracking is correctly set
(see Tracking Belt on Page 41).
3.
Loosen the knobs that secure the idler roller
guard and sleeve guard assembly, then
remove the guard.
4. Turn the sander ON.
Figure 53. Example of contour sanding.
5.
Slowly feed the workpiece into the curved
end of the belt and continue moving the
workpiece profile along the contour until you
achieve your desired shape, as shown in
Figure 53.
Do not operate this equipment when wear-
ing loose clothing, gloves, neckties, rings,
bracelets or other jewelry that might get
caught in the moving belt. Serious personal
injury may result. You must re-install the
idler roller and sleeve guard before perform-
ing edge or horizontal sanding operations.
6. Re-install the idler roller and sleeve guard.
-35-