Horizontal & Edge Sanding - Grizzly G1014Z Owner's Manual

Horizontal & Edge
Sanding
If the sanding belt frame is in the vertical posi-
tion, proceed to "Setting Up Sander for Horizontal
and Edge Sanding" below to setup the sander
for horizontal sanding. If the sander is already in
the horizontal position, skip ahead to "Performing
Horizontal Sanding and Edge Sanding."
Setting Up Sander for Horizontal
Sanding
1.
Loosen the set screws that secure the work
table support rod to the mounting bracket
behind the motor, then remove the work table
assembly (see Figure 49).
Set Screws
Figure 49. Location for removing work table
assembly.
-34-
2.
Loosen the sanding frame rotation lock nuts
(behind the sanding disc cover), rotate the
frame to the horizontal position, as shown in
Figure 50, then tighten the rotation lock nuts.
Sanding Disc
Cover
Rotation Nut (Hidden)
Figure 50. Table tilted to horizontal position.
3. Insert the table support rod into the hole in
the base under the sanding disc, and position
the work table ⁄
1
16
disc, as shown in Figures 29–30 on Page
24.
4.
Check that the miter gauge slot-sanding disc
distance is correct (see instructions on Page
51 for further detail).
5. Re-install the backstop so it is square with
" above the sanding belt (see Figure
and ⁄
1
8
37 on Page 26).
Performing Horizontal or Edge
Sanding
1.
Make sure the sanding belt is tensioned —if it
is not already tight.
2.
Make sure the belt tracking is correctly set
(see Tracking Belt on Page 41).
3. Turn the sander ON.
Model G1014Z/G1014ZX (Mfd. Since 07/17)
Rotation Lock
Nut
" away from the sanding