O 2 Trace; Fspo 2 Display Area; Single Versus Dual Display Of Spo 2; Fspo 2 Status Icons - GE Corometrics 126 Service Manual

%O Trace
2
FSpO Display Area
2
5-20
Setup Procedures: FSpO2 Setup Screen
This setting enables or disables the printing of the %FSpO
of the strip chart paper.
On: The %FSpO trend is printed as a beaded trace on the bottom (or right) grid
2
annotated by %FSpO
2
Off: The %FSpO trend is not printed.
2
Single versus Dual Display of SpO
If FSpO is monitored while MSpO
2
Parameters Area. Refer to Figure
information is displayed in the Waveform Area beneath the MSpO
waveform labels (speed, lead, scale) move to the left of the FSpO
waveform area, which would otherwise display about 4 seconds of information, is
reduced to show approximately 2.5 seconds of waveform data. Refer to
FSpO Status Icons
2
A status icon may appear above the %FSpO
information. Usually the message area will be blank; however, the icons

Sensor Unplugged

representing
Sensor Unplugged
disconnected from the fetal patient module cable; when the fetal patient module
cable is disconnected from the monitor; or when an invalid FSpO
connected to the fetal patient module cable.
)

Sensor Lifted

– This icon appears whenever the sensor is not making
adequate contact at the sensor site on the fetus.
( )

Pulse Search

– This icon is displayed when the monitor is attempting to
locate the fetal pulse. During successful monitoring, the message area is blank.
120 Series Maternal/Fetal Monitor
2015590-001
.
Figure 5-10. FSpO Trend
2
2
is inactive, FSpO displays in the Additional
2 2
6-4. When dual SpO monitoring occurs, FSpO
2
value to provide additional
2
Sensor Lifted Searching for Fetal Pulse
, , or
– This icon appears whenever: the FSpO
trend on the bottom grid
2
2
area. Any
2
area. The
2
Figure 6-5.
can appear.
sensor is
2
sensor is
2
Revision B