Standby Icsr System - Cisco ASR 5000 Series Administration Manual

Interchassis Session Recovery
a) Copy the file from a network location or local device plugged into the MIO/UMIO/MIO2 using the copy command.
host_name
[local]
b) Transfer the file to the /flash device using an FTP client with access to the system. The FTP client must be configured
to transfer the file using binary mode.
c) Transfer the file to the /flash device using an SFTP client with access to the system.
In release 20.0 and higher Trusted StarOS builds, FTP is not supported.
Step 4
Verify that the image file was successfully transferred to the /flash device by running the Exec mode the following
command:
host_name
[local]
Step 5
Run the show version /flash/image_filename command to verify the build information.
Any CRC errors will be displayed in the output of this command. If any errors appear, check the build and re-transfer it
onto the chassis. Confirm that the correct image version and build description is displayed

Standby ICSR System

Perform the tasks described below on the backup or standby ICSR system.
Performing Health Checks
Health checks are a series of Exec mode show commands to determine the readiness of the system to handle
a software update.
Step 1 Run show card table all |grep unknown. No output should be displayed.
Step 2
Run show card table |grep offline. No output should be displayed.
Step 3 Run show resources |grep Status. The output should display "Within acceptable limits".
Step 4 Run show alarm outstanding. Review the output for any issues that may preclude performing the software update.
Performing SRP Checks
Service Redundancy Protocol (SRP) checks verify that the mechanism for monitoring ICSR system status is
operational.
Step 1 Run show srp monitor all.
Step 2 Review the output for any issues that may preclude performing the software update.
copy from_url to_url [-noconfirm]
#
directory /flash
#
ASR 5500 System Administration Guide, StarOS Release 21.4
Standby ICSR System
365