Enable Or Disable Signature Verification - Cisco ASR 5000 Series Administration Manual

Enable or Disable Signature Verification

Enable or Disable Signature Verification
Use the following command to enable (or disable) signature verification in the configuration file:
Important
[ no ] cfg-security sign
Notes:
• Enabling signature verification (cfg-security sign command) will create an empty file named
• Use the no cfg-security sign command to disable verification of signature in the configuration file.
• The system looks for the .enable_cfg_pubkey file to determine if signature verification is enabled or
ASR 5500 System Administration Guide, StarOS Release 21.4
118
tftp://host[:port][/<directory>]/filename
ftp://[username[:password]@]host[:port][/directory]/filename
sftp://[username[:password]@]host[:port][/directory]/filename
http://[username[:password]@]host[:port][/directory]/filename
https://[username[:password]@]host[:port][/directory]/filename
This command can only be executed from the console.
.enable_cfg_pubkey in the same directory where the PEM file exists.
Disabling signature verification (no cfg-security sign command) will remove the .enable_cfg_pubkey
file.
disabled.
Secure System Configuration File