Fsc Drive N Activity Led States - Cisco ASR 5000 Series Administration Manual

Checking the LEDs on the FSC
Table 27: FSC Redundancy LED States
Color Description
Green Card is in redundant mode
Amber Card is not backed up by a
standby FSC.
Blinking Amber Tasks or processes being
migrated from an active FSC to
the standby FSC.
None Card is not receiving power.
OR
Card has failed.

FSC Drive n Activity LED States

The Drive 1 Activity and Drive 2 Activity LEDs on the FSC indicate that the RAID solid state drives (SSDs)
are being accessed by the MIO. Drive 1 and Drive 2 on each FSC form a RAID 0 configuration.
Important
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information also provided to diagnose the problem.
Table 28: FSC Driven Activity LED States
Color Description
Green Files are being transferred to or
accessed from the RAID
configuration by the MIO.
None There is no RAID activity.
OR
RAID configuration is
unavailable.
None Card is not receiving power
ASR 5500 System Administration Guide, StarOS Release 21.4
212
Troubleshooting
None needed. There is at least one FSC in Standby mode.
Check the status of the other FSCs. If one FSC has failed or has been removed
from the chassis, the system can continue to function but redundancy is
compromised.
Refer to Monitoring the System for information on determining the status of the
FSC and system software processes.
Refer to Monitoring the System for information on determining the status of the
FSC and system software processes.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST results are positive. If it is off, refer to
page 210
The FSC-400GB is equipped with a single 400 GB drive. Only the Drive 1 Activity LED will be active;
the Drive 2 Activity LED will always be off (None).
Troubleshooting
None required.
Checking the LEDs on the MIO Card, on page 202
FSC-400GB is not equipped with a second SDD. Only the Drive 1 Activity LED
will be active.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST results are positive. If it is off, refer to
page 210
for troubleshooting information.
for troubleshooting information.
Troubleshooting
FSC Run/Fail LED States, on
FSC Run/Fail LED States, on