Configuring Subscriber Vlan Associations - Cisco ASR 5000 Series Administration Manual

Configuring Subscriber VLAN Associations

Flow Control
Link Aggregation Group
Untagged:
Tagged VLAN: VID 10
Number of VLANs
SFP Module
Notes:
• Repeat this sequence as needed to verify additional ports.
• Optional: Configure VLAN-subscriber associations. Refer to
• Refer to
• Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Configuring Subscriber VLAN Associations
Subscriber traffic can be routed to specific VLANs based on the configuration of their user profile. This
functionality provides a mechanism for routing all traffic from a subscriber over the specified VLAN. All
packets destined for the subscriber must also be sent using only IP addresses valid on the VLAN or they will
be dropped.
RADIUS Attributes Used
The following RADIUS attributes can be configured within subscriber profiles on the RADIUS server to
allow the association of a specific VLAN to the subscriber:
• SN-Assigned-VLAN-ID: In the Starent VSA dictionary
• SN1-Assigned-VLAN-ID: In the Starent VSA1 dictionary
Important
Configuring Local Subscriber Profiles
Use the configuration example below to configure VLAN associations within local subscriber profiles on the
system.
ASR 5500 System Administration Guide, StarOS Release 21.4
302
: Enabled
: None
Logical ifIndex : 85262337
Operational State : Up, Active
Logical ifIndex : 285278210
VLAN Type : Standard
VLAN Priority : 0
Administrative State : Enabled
Operational State : Up, Active
: 1
: Present (10G Base-SR)
on page 302 for more information.
VLAN-Related CLI Commands , on page 303
Since the instructions for configuring subscriber profiles differ between RADIUS server applications, this
section only describes the individual attributes that can be added to the subscriber profile. Please refer to
the documentation that shipped with your RADIUS server for instructions on configuring subscribers.
Configuring Subscriber VLAN Associations,
for additional information.
VLANs