Apn Support – Pdn Gateway (P-Gw) - Cisco ASR 5000 Series Administration Manual

VLANs
APN Support – PDN Gateway (P-GW)
P-GW Access Point Name (APN) supports extensive parameter configuration flexibility for the APN. VLAN
tagging may be selected by the APN, but are configured in the P-GW independently from the APN.
Creating VLAN Tags
Use the following example to create VLANs on a port and bind them to pre-existing interfaces. For information
on creating interfaces, refer to System Interfaces and Ports.
config
port ethernet slot
Notes:
• Optional: Configure VLAN-subscriber associations. Refer to
• Repeat this procedure as needed to configure additional VLANs for the port.
• Refer to
• Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Verifying the Port Configuration
Run the following command to verify the port configuration:
[local]
An example of this command's output when at least one VLAN has been configured for the port is shown
below:
Port: 5/11
Port Type
Role
Description
Redundancy Mode
Redundant With
Preferred Port
Physical ifIndex
Administrative State
Configured Duplex
Configured Speed
Fault Unidirection Mode : 802_3ae clause 46
Configured Flow Control : Enabled
Interface MAC Address
SRP Virtual MAC Address : None
Fixed MAC Address
Link State
Link Duplex
Link Speed
port
/
no shutdown
vlan vlan_tag_ID
no shutdown
bind interface interface_name context_name
end
on page 302 for more information.
VLAN-Related CLI Commands , on page 303
additional information.
host_name show port info slot
#
: 10G Ethernet
: Service Port
: (None Set)
: Port Mode
: 6/11
: Non-Revertive
: 85262336
: Enabled
: Auto
: Auto
: 64-9E-F3-69-5B-EA
: 64-9E-F3-69-5B-CA
: Up
: Full
: 10 Gb
Configuring Subscriber VLAN Associations,
and the Command Line Interface Reference for
port
/
ASR 5500 System Administration Guide, StarOS Release 21.4
APN Support – PDN Gateway (P-GW)
301