Makita DA332D Instruction Manual
Cordless angle drill
Hide thumbs
Also See for DA332D:
- User manual ,
- Instruction manual (57 pages) ,
- Instruction manual (45 pages)
Related Manuals for Makita DA332D
Summary of Contents for Makita DA332D
- Page 1 INSTRUCTION MANUAL Cordless Angle Drill DA332D DA333D Read before use.
- Page 2 Symbols Vibration The following show the symbols used for the equip- The vibration total value (tri-axial vector sum) deter- ment. Be sure that you understand their meaning before mined according to EN60745: use. Model DA332D Work mode: drilling into metal Read instruction manual. Vibration emission (a ) : 2.5 m/s or less Uncertainty (K) : 1.5 m/s Model DA333D Only for EU countries...
- Page 3 Use personal protective equipment. Always SAFETY WARNINGS wear eye protection. Protective equipment such as a dust mask, non-skid safety shoes, hard hat or hearing protection used for appropriate conditions General power tool safety warnings will reduce personal injuries. Prevent unintentional starting. Ensure the WARNING: switch is in the off-position before connecting Read all safety warnings, instruc- to power source and/or battery pack, picking tions, illustrations and specifications provided with this...
- Page 4 Disconnect the plug from the power source Follow all charging instructions and do not and/or remove the battery pack, if detachable, charge the battery pack or tool outside the from the power tool before making any adjust- temperature range specified in the instruc- ments, changing accessories, or storing power tions.
- Page 5 CAUTION: Always install the battery cartridge causing fires, personal injury and damage. It will fully until the red indicator cannot be seen. If not, also void the Makita warranty for the Makita tool and it may accidentally fall out of the tool, causing injury to charger. you or someone around you. Tips for maintaining maximum...
- Page 6 Do not look in the light or see the NOTE: Depending on the conditions of use and the source of light directly. ambient temperature, the indication may differ slightly from the actual capacity. For model DA332D Battery protection system The tool is equipped with a battery protection system. This system automatically cuts off power to the motor to extend battery life.
- Page 7 Installing or removing drill bit Optional accessory For model DA332D ► 1 . Lamp Pull the switch lever to light up the lamp. The lamp keeps on lighting while the switch lever is being pulled.
- Page 8 Chuck key holder For model DA332D only (optional accessory) For model DA333D ► 1 . Chuck key holder 2. Screw To install the chuck key holder, fix it to the convex por- tion of the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then...
- Page 9 When drilling in wood, the best results are obtained CAUTION: These accessories or attachments with wood drills equipped with a guide screw. The guide are recommended for use with your Makita tool screw makes drilling easier by pulling the drill bit into specified in this manual. The use of any other the workpiece. accessories or attachments might present a risk of Drilling in metal injury to persons. Only use accessory or attachment...
- Page 12 Makita Europe N.V. Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 885606-229 www.makita.com 20170508...