Assigning Ip Address With Arp Command - Philips NetCam DVR Installation Instructions Manual

DVR_NC_ii_98911_0047.qxd
NetCam DVR
HDD Use: Click the 'HDD Enable' field to enable the NetCam DVR to record
images on it's HDD. If not enabled, the NetCam DVR will not record nor
replay. (Default figure is set to HDD disable. In this case, every button on a
main frame that relates to recording and replaying is disabled.) You can format
the HDD with the 'HDD Format' button. When the HDD is formatted, all
recorded images will be deleted.
PTZ
The NetCam DVR can control
pan/tilt/zoom functions, if pan/tilt
driver and zoom lens are installed.
However, you need to install the
communication protocol onto the
NetCam DVR to control
pan/tilt/zoom.
The NetCam DVR has some protocols installed for specific models of
pan/tilt/zoom. The communication protocols vary for each manufacturer. It is
recommended to use a pan/tilt/zoom that has the protocol installed. If you want
to install a pan/tilt/zoom whose protocol is not registered, please contact Philips
for information.
2.3.4

Assigning IP Address with ARP command

If you do not assign an IP address with the setup program, you can set it using the
ARP command.
Using ARP in Windows 98 and NT
Start a DOS window and type the following commands.
I
arp -s <NetCam DVR IP address> <NetCam DVR Ethernet address>
ping -t <NetCam DVR IP address>
Example
I
arp -s 200.243.232.178 00-40-8c-10-00-86
ping -t 200.243.232.178
18
12/13/00 1:53 PM Page 18
Section 2