Starting The Setup Program Of Netcam Dvr; Assigning The Ip Address And Setting Up The Netcam Dvr - Philips NetCam DVR Installation Instructions Manual

DVR_NC_ii_98911_0047.qxd
NetCam DVR
2.3.2

Starting the setup program of NetCam DVR

Ensure that the NetCam DVR Viewer is installed.
Click the file 'CamViewer.exe'.
I
The main frame of NetCam
DVR Viewer is displayed
Click the 'setup' button.
I
You can setup the NetCam DVR only
if it is connected on a local network.
2.3.3

Assigning the IP address and setting up the NetCam DVR

When the setup program is
selected, the window shows
every NetCam DVR
connected at the local
network.
From the NetCam DVRs list,
click the MAC address for the
one that you want to assign
an IP address and set up
When the NetCam DVR is
selected, an IP address is
displayed in the 'Selected IP
Address' box. (Default IP
address is 211. 53.133.92).
You should key in a password
in the 'Admin's Password' box to set up the NetCam DVR or to change the IP
address. Default password is 'admin'. You can change the IP address by clicking
the 'Change IP Addr' button or change the set up by clicking the 'Start' button.
12/13/00 1:53 PM Page 15
Section 2
15