Configuring Recording And System Conditions - Philips NetCam DVR Installation Instructions Manual

DVR_NC_ii_98911_0047.qxd 12/13/00 1:53 PM Page 23
NetCam DVR Section 3
3.3

Configuring recording and system conditions

Update:
When connecting the NetCam DVR, you can update the recorded
data to monitor by clicking the 'Update' button.
Update changes from to
Option:
You can configure the recording options by clicking the 'Option'
button.
Motion Detect Channel:
You can select a channel
that detects motion.
When this option is
enabled the NetCam DVR can detect motion, but the source channel is
restricted to one. Therefore, you should select which channel is assigned to
detect motion and send signals to it's CPU. You can set sensitivity of motion
detection via the 'THR' field. The range is from 1 to 999, where'1' is the
highest level, and '999' is relatively the lowest.
Normal Save:
You can select the
standard recording levels
with frame rate, image
resolution and image
quality (compressing rate). The quality level of the live image may also be
adjusted.
23