Rp Mode - Cisco catalyst 6500 series Configuration Note

Chapter 3 Getting Started
Configuring SLB Modes
persistent rebalance
serverfarm WEBFARM
inservice

RP Mode

You can use the ip slb mode rp command mode (the default) to configure multiple CSMs in a chassis
with Cisco IOS SLB. You can only configure the CSM using this mode starting from release 2.1.
In this mode, the CSM is configured from this command submode:
mod csm X
The X is the slot number of the CSM that you want to configure.
CSM show commands start with show mod csm X.
Beginning with CSM software release 2.1, the RP mode is the recommended mode when configuring the
CSM. While in this mode, all the commands apply to Cisco IOS SLB and not to a CSM in the chassis.
These commands begin with ip slb.
The following is an example of a configuration for a single CSM in the chassis:
Cat6k# show running-config
Building configuration...
Current configuration : 5597 bytes
!---
module ContentSwitchingModule 5
vlan 110 server
ip address 10.10.110.1 255.255.255.0
vlan 111 client
ip address 10.10.111.2 255.255.255.0
gateway 10.10.111.1
probe HTTP_TEST http
request method get url /probe/http_probe.html
expect status 200
interval 5
failed 5
serverfarm WEBFARM
nat server
no nat client
real 10.10.110.10
inservice
real 10.10.110.20
inservice
probe HTTP_TEST
vserver HTTPVIP
virtual 10.10.111.100 tcp www
persistent rebalance
serverfarm WEBFARM
inservice
Catalyst 6500 Series Content Switching Module Configuration Note
3-6
OL-4612-01