Advertisement
R
epair
2. Set sleeve to slider and turn it clockwise.
Fit sleeve with pin 3 (long) to slider as illustrated in Fig. 8.
<Note> No need to fix sleeve by inserting pin 3 (long) through
slider in this stage.
3. Set guide sleeve to slider and insert push plate into slider as illustrated in Fig. 9. Push the push plate in the
vertical direction with saw blade, and pass pin 3 (long) through the hole of push plate as illustrated in Fig. 9A.
Pin 3 (long)
Fig. 9
4. Remove guide sleeve and, push the driving sleeve toward the gear housing side turning it clockwise. Then
sleeve can be brought to the locked position with pin 3 (long). See Fig. 10 and Fig. 10A.
Guide sleeve
Push plate
Guide sleeve
Slider
Sleeve
Fig. 10
Pin 3 (long)
Fig. 8
Fig. 9A
Driving sleeve
Fig. 10A
P 6 / 15
Slider
Sleeve
Saw blade
Guide sleeve
Advertisement
