Advertisement
R
epair
(10) Disassembling handle section
1. Unscrewing 4 pcs. of tapping screws M4x30 and 2 pcs. of tapping screws M4x20, remove handle R
from handle L. So, the inner parts (for instance switch, terminal, etc.) can be removed. See Fig. 21.
Lock off butt
Handle R
2. Remove bumper, carbon brush and brush holder cap from motor housing. Then, brush holder can be removed.
See Fig. 22.
(11) Note in assembling handle section
Insert leaf spring for High-Low speed change lever into the groove of handle L and insert its another end into
the groove of handle R firmly. See Fig. 23.
After assembling, check whether speed change lever can be locked by leaf spring on "L" and "H" side
respectively, when speed change lever is slid.
This side has to come into
the groove of handle R.
Bumper
Carbon brush
Brush holder cap
Fig. 22
Leaf spring
Fig. 23
Tapping screws M4x30
Tapping screws M4x30
Tapping screws M4x20
Switch
Terminal
Fig. 21
Brush holder cap
Handle L
Carbon brush
Brush holder
P 13 / 15
Advertisement
