Advertisement
R
epair
3. Sleeve is in the lock position. In order to free from lock position, pull sleeve toward the blade installing side.
(When the sleeve is free from lock, pin 3 (long) is at the position illustrated in Fig. 5.
Blade installing side
Pull the sleeve to this
direction.
4. Holding the top of slider with your finger, remove sleeve by pushing pin 3 (long) with a small sticker
through slider as illustrated in Fig. 6.
< Note > When removing sleeve, always hold the top of slider with your finger as illustrated in Fig. 6.
Otherwise, push plate and compression spring 2 can spring out from slider as illustrated in Fig. 6A,
and they will get lost.
After removing sleeve, take off push plate, compression spring 2 and torsion spring 17 from slider
as illustrated in Fig. 6B.
Pin 3
Fig. 6
(3) Assembling blade clamp section
1. Assemble torsion spring 17 to slider. And then, set compression spring 2 into slider.
<Note> Pay attention to the position of the tail of torsion spring 17. It has to come to the right side
in the view from the side of shoe adjusting bolt M8x25, as illustrated in Fig. 7.
Torsion spring 17
Pin 3 (long)
Sleeve
Push plate
Compression spring 2
Sleeve
Pin 3
Gear housing side
Slider
Torsion spring 17
Fig. 5
Sleeve
Torsion spring 17
Compression spring 2
Push plate
Fig. 6A
Compression spring 2
Slider
The tail of
torsion spring 17
Threaded hole for hex bolt M8x25
Fig. 7
P 5 / 15
Sleeve
Fig. 6B
Advertisement
