Advertisement
R
epair
< 1 > Lubrication
Apply MAKITA grease N No.1 to the following portions marked with black triangle to protect parts and machine
from unusual abrasion. See Fig. 1.
Apply 12g.
< 2 > Sealing
Apply three bond 1215 to the following portion of gear housing cover which joins to gear housing, when assembling.
See Fig. 2.
< 3 > Disassembling and assembling
(1) Removing shoe
Turn lever 60 (adjusting lever for shoe), and take off pan head screw M4x10. Then, lever 60 can be removed.
Take off hex bolt M8x25 (This hex bolt can be unscrewed by using lock lever as a wrench.), and inner plate.
Remove shoe by pulling out. See Fig. 3.
Turn lever 60
(adjusting lever for shoe).
(2) Disassembling blade clamp section
Remove shoe as mentioned above. Pull out the blade clamp section, if it stays near gear housing.
1. Take off retaining ring S-18 with No.1R291 "Snap ring plier".
2. Take off driving sleeve, shoulder pin 5, compression spring 6,
pin 3, guide sleeve and driving sleeve guide from slider.
Gear housing
Fig. 1
Gear housing cover
Apply here three bond 1215
for sealing.
Fig. 2
Pan head screw
M4x10
Lever 60
Hex nut M4
Take off pan head screw M4x10.
<Note> Be careful, not to lose
hex nut M4 in lever 60.
Fig. 3
Retaining ring S-18
Driving sleeve
Shoulder pin 5
Compression spring 6
Pin 3
Sleeve
Fig. 4
Slider
Apply 7g.
Inner plate
Lock lever
P 4 / 15
Pull out shoe.
Hex bolt M8x25
Advertisement
