Cisco 10008 Installation And Configuration Manual page 56

show pxf cpu pbr action
show pxf cpu pbr action
To display policy-based routing (PBR) actions configured in the Parallel eXpress Forwarding (PXF), use
the show pxf cpu pbr action command in privileged EXEC mode.
Cisco 10000 Series Router
Syntax Description action map-name
tcam map-name
flex-sum
Command Modes
Privileged EXEC
Command History Release
12.2S
12.3(7)XI1
12.2(31)SB2
12.2(33)SB
Usage Guidelines
This command is useful to determine if an adjacency has been found for a set ip next-hop ip-address
route map configuration command.
Cisco 10008 Router PRE4 Installation and Configuration Guide
56
show pxf cpu pbr action map-name
show pxf cpu pbr [action map-name | tcam map-name | flex-sum]
(Optional) Displays PBR action information and redirects the command
output to the route map you specify.
(Optional) Displays VMR (value, plus a mask and result) information stored
in ternary content addressable memory (TCAM) and redirects the command
output to the route map you specify.
Note
(Optional) Displays summary information describing the amount of memory
allocated in the PXF engine for use by the flexible key construction
microcode. This information is useful for design teams.
Note
Modification
This command was introduced.
This command was introduced on the Cisco 10000 series router for the
PRE2.
This command was introduced on the Cisco 10000 series router for the
PRE3.
This command was introduced on the PRE4 for the Cisco 10000 series
router.
This option is only available on the PRE3 and PRE4 for the Cisco
10000 series router.
This option is only available on the PRE3 and PRE4 for the Cisco
10000 series router.
OL-13840-01