Tcam Commands - Cisco 10008 Installation And Configuration Manual

.
IPv6 Forwarding over MPLS
The Cisco 10008 router supports PXF–accelerated IPv6 packet forwarding over Multiprotocol Label
Switching (MPLS) on the PRE4. This feature is enabled by default.
Table 9
IOS Command Reference publication for your Cisco IOS software release.
Table 9
Command
Router(config)# ipv6 access-list
Router(config)# ipv6 cef
Router(config)# ipv6 cef distributed
Router(config)# ipv6 unicast-routing
Router(config-if)# ipv6 enable
Router(config-if)# ipv6 address
Router# show pxf cpu ipv6

TCAM Commands

This section describes the following commands for ACL lookup using the Ternary Content Addressable
Memory (TCAM) on the PRE4:
•
•
•
•
•
•
OL-13840-01
tunnel lookup
tunnel RX
tunnel TX
output qos
tag not ip
netflow accumulate
netflow age
netflow swap
lists common IPv6 commands. For more information about IPv6 commands, refer to the Cisco
IPv6 Forwarding over MPLS Commands
hw-module tcam, page 48
show pxf cpu access-lists, page 50
show pxf cpu pbr action, page 56
show pxf cpu qos, page 60
show pxf dma, page 62
show pxf tcam, page 65
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
Purpose
Configures an IPv6 access list and places the
router in IPv6 access list configuration mode.
Enables Cisco Express Forwarding for IPv6
(CEFv6).
Enables distributed CEFv6 (dCEFv6) to
process IPv6 packets from the Route
Processor (RP) to the line cards.
Enables the forwarding of IPv6 packets.
Enables IPv6 processing on an interface that
has not been configured with an explicit IPv6
address.
Configures an IPv6 address based on an IPv6
general prefix and enables IPv6 processing on
an interface,
Displays PXF IPv6 statistics.
Cisco 10008 Router PRE4 Installation and Configuration Guide
TCAM Commands
0
0
0
0
0
0
0
0
47