Cisco 10008 Installation And Configuration Manual page 31

Pre4
Table of Contents

Advertisement

> boot tftp://172.16.15.112/c10k4-p11-mz
The configuration dialog appears.
You can now proceed to step 9.
Booting from Disk0
If the image was saved to Disk0, boot that image.
The following boot command loads the PRE3 image from Disk0:
> boot disk0:c10k4-p11-mz
The configuration dialog appears.
You can now proceed to step 9.
Booting from the eboot Image
If you did not save the PRE4 image to a TFTP server, boot the eboot (c10k4-eboot-mz) image stored in
bootflash.
In the following example, the router boots from the eboot image:
> boot bootflash:c10k4-eboot-mz
The configuration dialog appears.
Proceed to the
Restore the startup and running configuration of the router.
Step 10
Saved the Configuration on a CompactFlash Card
If you booted the PRE4 image and saved the previous configuration to a CompactFlash card:
Exit the configuration dialog and restore the previously saved startup and running configuration
a.
from the CompactFlash card.
Update any boot commands to use the new PRE4 image.
b.
The router is available for normal operations and the upgrade is complete.
Saved the Configuration on a TFTP Server
If you booted the PRE3 image, and you saved the previous configuration to a TFTP server:
Enter the initial configuration dialog, and enter all required information to allow access to the TFTP
a.
server.
Assign the correct IP address for the Fast Ethernet interface to become active and for the TFTP
b.
server to become reachable. This may require adding an IP route for the server even after the initial
dialog completes.
Restore the previous configuration from the TFTP server to the startup and running configuration
c.
on the router.
Restore the startup and running configuration and update any boot commands to use the new PRE3
d.
image.
The router is available for normal operations and the upgrade is complete.
OL-13840-01
"Did Not Save the Configuration" section on page
32.
Cisco 10008 Router PRE4 Installation and Configuration Guide
Upgrading a PRE3 to a PRE4
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents