Siemens SINUMERIK 840D sl Function Manual page 536

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Diagnostics
10.2 NCK safety alarms for SINUMERIK 840D sl
27255
Parameter
Explanation
Response
Remedy
Program
continuation
27256
Parameter
Explanation
Response
Remedy
Program
continuation
27299
Parameter
Explanation
Response
10-536
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
PROFIsafe: F module %1, general error
%1 = PROFIsafe address
The specified PROFIsafe module signals an error: Additional informa-
tion on the cause of the error cannot be made without further re-
sources.
This alarm is initiated for all types of PROFIsafe slaves.
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Check the wiring
Remove the error and press RESET.
PROFIsafe: Actual cycle time %1 [ms] > parameterized cycle time
%1 = actual PROFIsafe communications cycle time
The actual PROFIsafe communication cycle time is greater than the
value set using MD $MN_PROFISAFE_IPO_TIME_RATIO. The para-
meterized PROFIsafe communication cycle time is continually ex-
ceeded on the PLC side.
Mode group not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Adapt the cycle time using MD $MN_PROFISAFE_IPO_TIME_RATIO.
At least the value, displayed in %1 must be set.
The selected cycle time has an effect on the runtime utilization of the
PLC module. This must be taken into account in the setting.
Remove the error and press RESET
PROFIsafe: Diagnostics %1 %2 %3 %4
%1 error ID 1
%2 error ID 2
%3 error ID 3
%4 error ID 4
Internal error in the NCK PROFIsafe implementation.
Alarm display
© Siemens AG 2008 All Rights Reserved
05.08

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics s120

Table of Contents

Save PDF