Siemens SINUMERIK 840D sl Function Manual page 447

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

05.08
Measuring parameters
For the measuring parameters, the measuring time, the trigger time, specific
thresholds and various trigger signals can be set (e.g. a trigger from the part pro-
gram). These settings are used to parameterize the PI services at the NCK using
the vertical "start" softkey. A measurement that has already been started can be
interrupted using the vertical "stop" softkey. In this case, the NCK does not supply
any measured values.
Physical address
If the physical address entry is selected in the signal selection list, the vertical soft-
key having the same name is activated. Using the input masks under this softkey,
segment values and offset values of NCK system variables etc. can be specified
and then measured.
It is possible to scroll through the axes and spindles in the application using the
vertical "Axis +" and "Axis –" softkeys. The axis name or spindle name is included
in the selected selection list for the axis/spindle names.
Selecting SGE drive
The selection of the SI signal SGE drive (from the PLC) is shown in the following:
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Diagnostics
10.1 Troubleshooting procedure
10-447

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics s120

Table of Contents

Save PDF