Pan Eot Sensor Replacement - Philips VL3000 Service Manual

Pan EOT Sensor Replacement

VL Part No: 23.9678.0687
Repair/Replacement Procedure
Step 1. Using console or internal menus, run lens as far to the rear as possible.
Step 2. Disconnect luminaire AC input cable from power source.
CAUTION: Be careful not to damage lens during next step.
Step 3. Carefully lay luminaire on its side, ensuring that lens does not come into contact with any
surface.
Step 4. At bottom of enclosure, remove four 1/4-20x1/2" socket screws and 1/4" split lock washers
and remove ventilation cover.
Step 5. At pan sensor, remove two 6-32x3/8" PPZ screws.
Step 6. Disconnect wiring from encoder PCB and remove sensor.
Step 7. Replace sensor by performing steps 3 through 6 in reverse order.
Bottom Cover
02.96 78.001 0 G
M P
AINTENANCE ROCEDURES
NOTE:
Head not shown for clarity.
Pan Motor
Assembly
Figure 2-14: VL3000 Pan EOT Sensor Replacement
: P EOT S R
AN ENSOR EPLACEMENT
Enclosure Bottom View
Sensor
2
33