Table 2-45 Pt Function Block Configuration Parameters - Honeywell UMC800 Reference Manual

Function Blocks
2.51 PT Function Block,
Configuration Parameters, continued

Table 2-45 PT Function Block Configuration Parameters

Properties Group
Block
Period
Reset/Cycle
160
continued
Parameter Index#
N/A
Block
Order
Monthly N/A
Weekly N/A
N/A
Daily
N/A
Time/Cycle
N/A
Function Block Reference Guide
Parameter Description
Output turns ON once a
month for one scan cycle.
If the current month's last day
is less than 31 it will turn ON
on the last day of the month.
Reset/Enable:
ON = Hold off output
OFF = Run
Output turns ON once a week
for one scan cycle.
Reset/Enable:
ON = Hold off output
OFF = Run
Output turns ON once a day
for one scan cycle.
Reset/Enable:
ON = Hold off output
OFF = Run
Timer starts at a specific time
of day then output pulses
on/off on a time interval. Once
started, start time is ignored
until reset.
Reset Input:
ON = stops cycle and holds
off start
OFF = enables start time
Timer starts on an ON (1) to
OFF (0) transition of the reset
input, then output pulses
on/off on a time interval. Once
started, the cycle continues
until the reset turns on.
Reset Input:
ON = stops cycle and holds
off start
OFF = Output turns ON for
one scan cycle at ON to OFF
transition and cycle begins.
Value or Selection
Read Only. See
"Configure" Menu,
"Execution Order" to
change.
Enter START -
Day(Days >31 = 31),
Hour, Minute,
Seconds
Enter at START -
Day (Monday through
Sunday
Hour, Minute,
Seconds
Enter at START -
Hour, Minute,
Seconds
Enter at START -
Hour, Minute,
Seconds
Enter at CYCLE -
Hour, Minute,
Second
Enter at CYCLE -
Hour, Minute,
Second
Table continued next page
3/99