Honeywell UMC800 Reference Manual page 238

Function Blocks
2.74 TPSC (3POS) Function Block,
Configuration Parameters, continued
MOTOR TAB
It looks like this graphically on the Control Builder. Three Position Step control is accomplished by
assigning the motor control relays physical address under this tab.
the value or selection.
Example
ATTENTION: TPSC output addresses are not checked for redundant assignment or mismatch with
controller hardware; therefore, use caution to insure unique address and correct I/O module.
228
continued
Function Block Reference Guide
Table 2-64 describes the parameters and
Continued next page
3/99