Applicable Specification Of Magnetic Contactor And Wires - GE VAT200 Quick Start Manual

※Notice
To avoid shock hazards, do not touch any electrical component when the power is applied or
just after five minutes the power plug is unplugged. The other action should be performed
after the charge indicator went off.
Do not perform wiring on the inverter while it is still electrified. Disregard of this notice
could cause serious injure or death to persons.
※
This product is designed to use in Pollution Degree 2 environment or equivalent environments.

3.3.2 Applicable specification of magnetic contactor and wires

Molded-case circuit breaker/magnetic contactor
GE bears no responsibility to service for failures caused by the following conditions:
(1) A molded-case circuit breaker is not installed, or an improper or overrated breaker is
used, between the power source and the inverter.
(2) A magnetic contactor, a phase capacitor, or a burst absorber is connected between the
inverter and the motor.
VAT200 model
Molded-case circuit
breaker made by GE
Magnetic contactor (MC)
made by GE
Main circuit terminals
(TM1)
Signal terminals (TM2)
VAT200 model
Molded-case circuit
breaker made by GE
Magnetic contactor
CL01 for X04K0
(MC) made by GE
Main circuit terminals
Wire gauge 2.0mm
(TM1)
Signal terminals (TM2)
Use three-phase cage induction motor with capacity suitable for the inverter.
One inverter is driving several motors, the total current of all motors running simultaneously
must be less than the rated current of the inverter, and each motor has to be equipped with a
proper thermal relay.
Do not add capacitive component, such as a phase capacitor, LC or RC, between the inverter
and the motor.
N00K4 N00K7
GPS2M_
GPS2M_AN
AM
20A
16A
CL00 CL01
Wire gauge
2
2.0 mm
X00K7, X01K5,
X05K5
X02K2, X04K0,
GPS2M_AM _AN
16A 20A
CL00
CL02
Wire gauge
2
3.5mm
Wire gauge 0.75mm
Chapter 3 Ambient Environment and Installation
N01K5 N02K2
GPS2M_AR GPS2M_AR
32A 32A
CL01 CL02
Wire gauge
3.5 mm
2
Wire gauge 0.75mm ( # 18 AWG)
X07K5 X11K0 X15K0 X18K5 X22K0 X30K0 X37K0 X45K0
_AR _AT _AT
32 50A 50A
CL25 CL04
CL45 CL06 CL06 CL07 CL08
Wire
Wire gauge
gauge
8mm
2
2
5.5mm
2
( # 18 AWG), terminal screw M3
3-5
N04K0 N05K5
GPS2M_AR GPS2M_AT
32A 50A
CL25 CL04
Wire gauge 5.5 mm
2
FD FD FD FD
80A 100A 100A 125A
Wire
Wire gauge
gauge
2 2
22mm
2
14mm
N07K5
GPS2M_AU
63A
CL45
2
X55K0
FD FE
100A 200A
CL09 CK75
Wire Wire
gauge gauge
2 2
38mm 60mm