Table of Contents
Advertisement
Preliminary - Subject to Change Without Notice
8.A.(2)(c) Reconnect appropriate cables to connector J10521.
8.B. KPA 1052 Power Amplifier Removal and Re-installation
8.B.(1) KPA 1052 Power Amplifier Removal
8.B.(1)(a) Detach cables from connector J10524.
8.B.(1)(b) Remove nut and washer on the GND post. Detach ground
8.B.(1)(c) Loosen retaining screw clamp loacted at the front of
8.B.(2) KPA 1052 Power Amplifier Re-installation
8.B.(2)(a) Slide the KPA 1052 Power Amplifier gently into the
8.B.(2)(b) Engage and tighten retaining screw clamps to secure
8.B.(2)(c) Reconnect appropriate cables to connector J10524.
8.C. KRX 1053 Receiver/Exciter Removal and Re-installation
8.C.(1) KRX 1053 Receiver/Exciter Removal
8.C.(1)(a) Detach cables from connector J10531.
8.C.(1)(b) Loosen retaining screw clamp located at the front of
8.C.(2) KRX 1053 Receiver/Exciter Re-installation
8.C.(2)(a) Slide the KRX 1053 Receiver/Exciter gently into the
8.C.(2)(b) Engage and tighten retaining screw clamps to secure
8.C.(2)(c) Reconnect appropriate cables to connector J10531.
8.D. Control Unit Removal and Re-installation
Revision 0
10640I00.SLK
KHF 1050 SYSTEM INSTALLATION MANUAL
strap. Replace nut and washer on the GND post.
the KPA 1052 Power Amplifier. Remove unit from rack.
mounting rack.
unit.
the KRX 1053 Receiver/Exciter. Remove unit from
mounting rack.
mounting tray.
unit.
N
23-10-09
Page 2044
Mar/2003
Hide quick links:
Advertisement
Table of Contents
