Table of Contents
Advertisement
Preliminary - Subject to Change Without Notice
5.B.(6)(a)2 Inverted "V" Antenna Mounting Location
5.B.(6)(b) Long Wire Antenna Mounting Location
Revision 0
10640I00.SLK
KHF 1050 SYSTEM INSTALLATION MANUAL
The inverted "V" antenna is recommended when a wing "V"
is not practical and the antenna coupler is to be
mounted in the aft position of the aircraft. The
inverted "V" antenna will produce maximum signal
strength off the side of the aircraft and will produce
a moderate amount of drag.
The vertical fin anchor should be located as high as
possible on the vertical stabilizer. The feedthru
insulator should be located approximately 3 feet (0.9
m) forward of the base of the vertical stabilizers and
near the centerline of the top of the aircraft.
Typical Inverted "V" Antenna
The long wire antenna is used when the KAC 1052 Antenna
Coupler is located in the forward part of the aircraft.
It will provide maximum signal radiation off the sides
of the aircraft. Significant nulls in signal strength
may be noted off the nose and tail of the aircraft.
N
Figure 2002
23-10-09
Page 2006
Mar/2003
Hide quick links:
Advertisement
Table of Contents
