Description And - Honeywell KHF 1050 System Installation Manual

Preliminary - Subject to Change Without Notice
5.C.(4) Antenna Cable Type
The cable connecting the KAC 1052 antenna output (J10528)
to the antenna or antenna feed-through must be a specially
fabricated feedline supplied by Honeywell. Due to the high
level of RF voltage the KHF 1050 system is capable of
generating, substitute cables must not be used. Refer to
Section 1.C.(1) for appropriate part numbers for the
Honeywell supplied HN-to-HN feedline assemblies.
5.C.(5) Connectors
Mating connectors for the KHF 1050 HF system components
are identified on the appropriate outline drawing.
Associated connector installation kits are specified in
DESCRIPTION AND OPERATION section of this manual.
Crimping, insertion, extraction tools are identified in
section 5.C.(6).
5.C.(5)(a) KAC 1052 Antenna Coupler Connector
KAC 1052 Antenna Coupler Connector (J10521) Pin Configuration
PIN
1
2
3
4
6
7
8
9
Revision 0
10640I00.SLK
KHF 1050 SYSTEM INSTALLATION MANUAL
KAC 1052 CONNECTOR PIN DEFINITIONS
SIGNAL NAME
PRI PWR RTN
PWR CONT RTN
STRP A
STRP COM
RCA
CRA
BUS COM
EXCTR INHB +
N
Figure 2009
DESCRIPTION
PRIMARY POWER RETURN
POWER ON/OFF CONTROL RETURN
STRAP A
STRAP COMMON
CPLR TXD BUS +
CPLR RXD BUS +
BUS COMMON
EXCTR INHIBITION +
23-10-09
Page 2013
Mar/2003