Tray 4 Error; Cartridge Error - Brother HL-L8260CDN Online User's Manual

Error Message
Toner Low: X
(X indicates the toner cartridge
or drum unit colour that is near
the end of its life. BK=Black,
C=Cyan, M=Magenta,
Y=Yellow.)
Too Many Trays
Tray 2 Error
Tray 3 Error

Tray 4 Error

Unusable Device
Unusable Device
Remove the Device. Turn
the power off and back
on again.
WT Box End Soon
HL-L8360CDW/HL-L9310CDW
Error Message
2-sided Disabled
Access Denied
Calibration

Cartridge Error

Condensation
Cooling Down
Cause
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
The number of installed Optional
Trays exceeds the maximum
number.
The optional lower tray is not
installed correctly.
An unsupported USB device has
been connected to the USB host
connector.
A defective USB device or a high
power consumption USB device
has been connected to the USB
direct interface.
The waste toner box is almost full. Order a new waste toner box before the LCD
Cause
The back cover of the machine is
not closed completely.
The function you want to use is
restricted by Secure Function
Lock 3.0.
Calibration failed.
The toner cartridge is not installed
correctly.
Condensation may have formed
inside the machine after a room
temperature change.
The temperature of the inside of
the machine is too hot. The
machine pauses its current print
job and goes into cooling down
mode.
Action
Order a new toner cartridge before the LCD
displays Replace Toner.
Reduce the number of Optional Trays.
Reinstall the lower tray.
Unplug the device from the USB host
connector.
• Unplug the device from the USB direct
interface.
• Press and hold to turn the machine off,
and then turn it on again.
displays Replace WT Box.
Action
Close the back cover of the machine until it
locks in the closed position.
Call your administrator to check your Secure
Function Lock Settings.
• Press and hold down
machine off. Wait a few seconds, and then
turn it on again. Perform the colour
calibration again using the LCD.
• Install a new belt unit.
• If the problem continues, contact Brother
customer service or your local Brother
dealer.
Pull out the drum unit, remove the toner
cartridge for the colour that is indicated on the
LCD, and place it back in the drum unit. Install
the drum unit in the machine again.
If the problem continues, contact Brother
customer service or your local Brother dealer.
Leave the machine turned on. Wait for 30
minutes with the front cover in the open
position. Then turn off the machine and close
the cover. Turn it on again.
Wait until the machine has finished cooling
down. Make sure all vents on the machine are
clear of obstructions.
When the machine has cooled down, the
machine will resume printing.
to turn the
259