Table of Contents
Advertisement
7847i-E Installation and Setup Guide
Using the Control Panel Programming Mode
Some control panels support programming of the 7847i-E through the control panel
programming mode (e.g., Vista-128BP). If programming through the control panel, only the
ECP Mode programming options are available. The "mode" questions will not be displayed,
and the mode cannot be changed. For a description of key functions on the control panel
keypad, and how they map to the 7720P Programming tool, refer to the control panel's
Programming Guide.
Programming Conventions
Programming is accomplished by answering a series of prompts (questions). Most prompts
require only a [Y]es or [N]o response, while others require a numerical response (ID
numbers, etc.).
The current value is displayed on the second line in parentheses ( ). A "?" indicates an
invalid entry.
Use the [ENTER] key to accept the current entry and proceed to the next prompt. If the
current value is invalid, pressing [ENTER] re-displays the prompt; the next prompt is not
displayed until a valid answer is entered.
Use the up/down arrow keys to scroll through the programming questions without changing
any values. Press the [ESC] key to go to the end of the list of questions.
ECP Mode Programming
Press the [ENTER] key to begin programming.
NOTES: 1. The central station can remotely block access to local device
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password:
2
Program Device?
3
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)_
3-2
programming. If this has been done, the following prompt
appears:
2. The default programming values for ECP mode are listed in
each prompt below.
Table 3: Programming a 7847i-E for ECP mode only.
ENTRY
OPTIONS
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N]
[Y], [N]
[Y], [N]
DESCRIPTION
Enters programming mode.
If a password has been previously assigned, this prompt
appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
To begin programming the module, press [Y] and go to
Prompt 9: "Device Mode."
To create a password if none has been assigned, press
[N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt appears
after pressing [N] at the "Program Device?" prompt.
If a password is desired, press [Y] and go to Prompt 6:
"Enter Password."
If a password has already been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt. Press [Y] if you want to change the password.
NOTE: To clear an existing password, without entering a
new one, answer [Y] to the "Change Password?" prompt,
Access to Prog
Mode Denied
Hide quick links:
Advertisement
Table of Contents
