Test Run - Grizzly G0750G Owner's Manual

4. Make sure the wires have enough slack
between the strain relief and terminal connec-
tions so they are not pulled tight or stretched,
then tighten the strain relief to secure the
cord.
Note: The strain relief must be tightened
against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.
5.
Test the strain relief to ensure it is properly
tightened by pulling the cord from outside the
box with light-to-moderate force. When the
strain relief is properly tightened, the cord will
not move inside the cabinet.
6.
Install a NEMA 6-15 plug on the other end of
the power cord per the plug manufacturer's
instructions.
7.
Re-install the main electrical box cover.
To avoid unexpected start-up, keep the
RESET button pressed in until instructed
otherwise in the Test Run.
8. Plug the cord into the matching power supply
receptacle and power source as specified in
Circuit Requirements for 220V on Page 14.
Model G0750G (Mfd. Since 5/15)

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, 2) the
emergency stop/RESET button safety feature
works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run your machine:
1. Read and follow the safety instructions at the
beginning of the manual, take all required
safety precautions, and make sure all pre-
vious preparation steps discussed in this
manual have been followed and completed.
2.
Clear away all tools and objects used during
assembly, lubrication, and preparation.
3.
Make sure that the chuck and jaws, if installed,
are secure (refer to Chuck Installation on
Page 30).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test.
-25-