NEC UNIVERGE SV8100 Features & Specifications Manual page 1142

Issue 5.0
Program
Number
25-07-02
25-07-03
25-08-01
25-13-01
25-15-01
25-15-02
31-02-01
31-02-02
1 - 1132
Program Name
System Timers for VRS/DISA –
VRS/DISA No Answer Time
System Timers for VRS/DISA –
Disconnect after VRS/DISA
retransfer to IRG
DISA User ID Setup – Password
System Option for DISA – VRS
Message Access Password
DISA Transfer Target Setup –
DISA Transfer Target Area at
Wrong Dial
DISA Transfer Target Setup –
DISA Transfer Target Area at No
Answer or Busy
Internal Paging Group
Assignment – Internal Paging
Group Number
Internal Paging Group
Assignment – Internal All Call
Paging Receiving
Description/Comments
If an Automated Attendant caller
dials an extension that does not
answer, the call waits this interval
before rerouting to the Ring Group
specified in PRG 25-03 and PRG
25-04. This setting also affects
unanswered DISA calls.
Set the timer for disconnecting a
call after it is re-transferred to a
ring group by VRS/DISA.
Set up password (six digits).
Enter the password DISA callers
must dial before the system allows
them to record, listen to or erase
VRS messages.
Used to assign a speed dial
number when the wrong number is
received.
Used to assign a speed dial
number when a dial tone times-out
and the target extension does not
answer or is busy.
Assign extensions to Internal
Paging Groups (i.e., Page Zones).
Enable or disable All Call Internal
Paging for each extension. If
allowed, extension can place and
receive All Call Internal Paging
announcements. If prevented,
extensions can only make (not
receive) All Call Internal Paging
announcements. If combined,
Paging zones should be restricted
as well, change the internal page
zone group in Program 31-07-01
to 0.
Voice Response System (VRS)
UNIVERGE SV8100
Assigned Data
0~64800 (seconds)
(default = 0 seconds)
0~64800 (seconds)
(default = 60 seconds)
Dial (Six digits fixed)
* #
(0~9, , )
(default not assigned)
*
#
1~ 9, 0, ,
Six digits fixed
(default not assigned)
Speed Dial bin number
0 ~ 1999
(default = 1999)
Version 3 software or
higher is required
Speed Dial bin number
0 ~ 1999.
(default = 1999)
Version 3 software or
higher is required.
0~64
(0 = No Setting)
Default:
0 for IP Station
1 for TDM Station
0 = Off
1 = On
(default = 0)