Hart Calibration For St 700 Standard Transmitter; About This Section; About Calibration; Equipment Required - Honeywell ST 700 User Manual

8 HART Calibration for ST 700 Standard Transmitter

8.1 About This Section

This section provides information about calibrating an ST 700 Standard Transmitter's analog output
and measurement range. It also covers the procedure to reset calibration to the default values as a
quick alternative to measurement range calibration.
This section includes the following topics:

How to calibrate a Transmitter's analog output circuit using the Communicator

How to perform a two-point calibration of a Transmitter

How to perform a correct reset to return a Transmitter calibration to its default values.

8.1.1 About Calibration

The ST 700 Standard SmartLine Pressure Transmitter does not require calibration at periodic
intervals to maintain accuracy. If a recalibration is required, we recommend that perform a bench
calibration with the Transmitter removed from the process and located in a controlled environment to
get the best accuracy.
Before you recalibrate a Transmitter's measurement range, you must calibrate its analog output
signal. See Section 7.5 for the procedure.
You can also use the FDC application to reset the calibration data to default values, if they are
corrupted, until the Transmitter can be recalibrated. See Section 7.8 for details.
All procedures in this manual assume the Transmitter is configured for Loop Current
Mode enabled).

8.1.2 Equipment Required

Depending on the clicked calibration, you may need any of the following test equipment items to
accurately calibrate the Transmitter:

Digital Voltmeter or millimeter with 0.02% accuracy or better

MC Toolkit Calibration standard pressure source with a 0.02% accuracy

250ohm resistor with 0.01% tolerance or better.
Revision 4.0
ST 700 Series HART/DE Option User's Manual
Page 69