Safety Certification Information; Transmitter Adjustments - Honeywell ST 700 User Manual

13.3 Safety Certification Information

An "approvals" name plate is located on the bottom of the Electronics Assembly; see
eference source not found. 2
and service marks that disclose the Transmitter compliance information. Refer to the Approvals
sections of the ST 700 SmartLine Transmitters User's Manual, Document # 34-ST-25-44 for details.

13.4 Transmitter Adjustments

Zero and Span adjustments are possible in new generation ST 700 Basic SmartLine Pressure
Transmitter by using the optional two-button assembly located at the top of the Electronic Housing
(see Figure 16). However, certain capabilities are limited in the following configurations:
 Without a display: When no display is present you can do Set Zero (with zero button), Set
span (with span button) and zero correct (when both the buttons are pressed
simultaneously for more than 10 sec).
 With a display: Limited Transmitter configuration is possible for HART devices.
You can also use the Honeywell MCT404/202 Configuration Tool to make any adjustments to an ST
700 Transmitter. The MCT404/202 tool has FDC application. Using the Field Device Configurator
(FDC) application, you can adjust the ST 700 HART model configuration.Certain adjustments can
also be made through the Experion Station if the Transmitter is digitally integrated with a Honeywell
Experion system.
ST 700 HART models can be configured using Honeywell tools such as Experion in conjunction with
FDM, using DTMs running in FDM or Pactware, or Emerson 375 or 475.
Page 114
for the exact location. The approvals name plate contains information
ST 700 Series HART/DE Option User's Manual
Error!
Revision 4.0