Setup And Operation - Cisco GS7000 Installation And Operation Manual

4 Chapter 4

Setup and Operation

Introduction
This chapter describes how to set up and operate the 1.2 GHz GS7000
Node. These procedures assume the 1.2 GHz GS7000 Node is installed
according to the procedures in Chapter 3 of this manual.
Network Requirements
Refer to your network design diagrams during setup. The design
diagrams should specify the exact input and output signal levels
required for your network. The 1.2 GHz GS7000 Node is configured to
have a specific amount of gain at 18 dB of linear tilt from 52 MHz to
1218 MHz.
In This Chapter

Tools and Test Equipment ................................................................... 90

System Diagrams .................................................................................. 91

Forward Path Setup Procedure ........................................................... 97

Reverse Path Setup Procedure .......................................................... 101

Reconfiguring Forward Signal Routing........................................... 103

Reconfiguring Reverse Signal Routing ............................................ 113
89