Setup And Operation - Cisco GS7000 Installation And Operation Manual

4 Chapter 4

Setup and Operation

Introduction
This chapter describes how to set up and operate the 1.2 GHz SHO
GS7000 Node. These procedures assume the 1.2 GHz GS7000 Node is
installed according to the procedures in Chapter 3 of this manual.
Network Requirements
Refer to your network design diagrams during setup. The design
diagrams should specify the exact input and output signal levels
required for your network. The 1.2 GHz SHO GS7000 Node is
configured to have a specific amount of gain at 22 dB of linear tilt from
52 MHz to 1218 MHz.
In This Chapter

Tools and Test Equipment .................. Error! Bookmark not defined.

System Diagrams ................................. Error! Bookmark not defined.

Forward Path Setup Procedure .......... Error! Bookmark not defined.

Reverse Path Setup Procedure ........... Error! Bookmark not defined.
57